Perkins 12kW diesel generator Fuel Consumption
The Perkins 12kW diesel generator is powered by a Perkins engine 403A-15G2. It has a special enclosure to reduce noise in any weather, keeping it at 65db at a 7m distance. It also has a built-in fuel tank so you don’t have to refuel often, using less than 3.3L/h of fuel consumption. An AVR guarantees stable power and has safety features like automatic shutdown for low oil levels or other problems.
POWER OUTPUT:
13.2KW (16.5KVA) STANDBY, 12.0KW (15.0KVA) PRIME, 3PHASE, 0.8PF, 50HZ
Datasheet of Perkins 12kW Diesel Generator
- Genset Supplier – METCL
- Genset Model – P16GFS
- Generator Speed – 1500 RPM
- Displacement – 1.496 Litre
- Fuel Consumption at rated 12kW/15KVA Load- 3.3 Litre/h
- Kubota Engine 403A-15G2, 15.2kW, 1500RPM, Turbocharged
- Electronic Speed Governor
- Radiator cooling system with fan guards and coolant drain extension with in-line valve
- AC Alternator Producer – STAMFORD/Leroy-Somer/Mecc Alte
- AC Alternator 4 Leads, brushless, 100% Copper Windings
- Full load rated Power – 12kW/15kVA
- 50 Hz. 1500RPM 3Phase AC400V
- 3-Phase AC380/415/440V etc Multi-voltage as optional
Features of Perkins Engine 403A-15G2
- The 403A-15G2 ElectropaK is a powerful but quiet 1.5 litre naturally aspirated 3-cylinder compact package
- Design features on the 400D range of ElectropaKs ensure clean rapid starting in all conditions whilst delivering impressive performance with low operating costs in a small, efficient package size
- Approved for operation on biodiesel* concentrations of up to 20%
- Oil and filter changes are 500 hours, dependent on the load factor
- Engine durability and reliability, the warranty offering, and ease of installation combine to drive down the cost of
ownership - Perkins Engine provides one-year warranties for constant-speed engines and two-year warranties for variable-speed models, as standard.
Perkins 12kW diesel generator Fuel Consumption
GENERAL PERKINS ENGINE 403A-15G2 DATA SHEET
Air Inlet
- Mounted air filter
Fuel System
- Mechanically governed cassette-type fuel injection pump
- Split element fuel filter
Lubrication System
- Wet steel sump with filler and dipstick
- Spin-on full-flow lube oil filter
Cooling system
- The thermostatically-controlled system with a belt-driven coolant pump and pusher fan
- Mounted radiator, piping, and guards
Electrical equipment
- 12 volt starter motor and 12 volt 15 amp alternator with DC output
- Oil pressure and coolant temperature switches
- 12-volt shut-off solenoid energized to run
- Glow plug cold start aid and heater/starter switch
Flywheel and housing
- 1500 rev/min
- High inertia flywheel to SAE J620 Size 190.5 mm (7½ in) Heavy
- Flywheel housing SAE 4 Long
Mountings
- Front and rear engine mounting bracket
Optional equipment
- Parts book
Option groups
- A selection of optional items is available to enable you to prepare a specification precisely matched to your needs